article

VALIMPEX, s.r.o.
Karadžičova 47, 811 07 Bratislava

ensk

Injection

VALIMPEX, s.r.o. has various products for preventive and repair injection of leaking below and above grade concrete structures such as shafts, caverns, tunnels, parking’s, metros and dams. 

We offer the following Systems based on:

  • Polyurethane one component solvent free and two components solvent free products.

  • Methacrylate based injection system for sealing and consolidation in presence of water it cures to a soft, elastic and tacky crosslinked gel.

  • Urea-silicate for filling cavities, ground stabilization and stopping strong water ingress.

  • Silane-siloxane Injection of masonry walls against ascending humidity (rehabilitation of old buildings).

Work place before injection

Work place after injection

work place after injection work

VALINJECT 1C SOIL

VALINJECT 1C SOIL polyurethane injection system is a one component solvent free, very low viscosity pre-polymer ideally suitable for soil stabilization.

VALINJECT 1C SOIL
Download

VAL® FOAM

VAL FOAM is a hydrophilic and solvent free low viscosity polyurethane injection resin for moving non-structural cracks.

VAL® FOAM
Download

VALINJECT® PUS

This is a two-component urea silicate foam, which is highly reactive. It is much recommended for cavity fillings.

VALINJECT® PUS
Download

VALINJECT® CS

VALINJECT® CS is an environmentally friendly, highly stable, single component, ultra-low viscosity colloidal silica primarily used for injection into sands, silts, and fine jointsand fissures in rock strata. VALINJECT® CS is available in three grades with varying SiO2 content . By adjusting the accelerator dosage it canbe used where very slow migration and penetration capabilities are required..

VALINJECT® CS
Download

VALINJECT® 2C

This is a two-component polyurethane injection system, which is highly reactive. It is much recommended for water carrying structures (against pressurized water). It is CFC and Halogen free.

VALINJECT® 2C
Download

VALINJECT® 1C FLEX

This is a single component, solvent free, polyurethane injection system, which is highly recommended for water cut‐off in wet dynamic cracks/ joints. When reacts with water, forms a very flexible PU foam.

VALINJECT® 1C FLEX
Download

VALINJECT® 1C 115 ECO

This is a single component, solvent free, polyurethane injection system, which is highly recommended for crack injection/water leaks in concrete and masonry structures.When reacts with water, forms a semi-rigid polyurethane foam (slightly flexible). Recommended for concrete and Masonry structures.

VALINJECT® 1C 115 ECO
Download

EPOXY INJECTION